September 25, 2020, 07:54:52 pm


Have you visited the Allwinner Chipset wiki? -

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - ahha007

The EMMC controller maybe don't support V5.0 spec.
You can refer to the datasheet of A80 here
Quote from: ybmaker on August 15, 2014, 12:56:36 pm
     I'm Jacky ! I worked for Allwinner over the past three years ! Now I am a member of the ybmaker team to develop many useful and interesting open source projects.
     Today, I bring a 3.5" TFT(800 x 480 pixels) with capacitive touchscreen for your cubieboard1 or cubieboard 2 , so we never need a very big monitor again! cubieboard with this screen can run android and ubuntu now!
      If you want to learn more about it ,please click :

      we have used XSTroke for handwriting input !

      it can easly play 720p video by mplayer .

      Android 4.2 .     

      WOW ! I welded this board, but it's not beautiful ! we plan to ask for help from SMT manufactory in Shenzhen ,China.

      The TFT and the LCD interface of the cubieboard were  connected !

      This project is open source !
      The price is $30, do you think it's reasonably priced ?
      Do you want one ? or you have any suggestions , please reply me , thank you!

Small and exquisite, it looks very nice!
Thanks for your team's working.
Beginners / Re: What parts are where on a cubieboard
April 20, 2014, 04:31:34 pm
you can download the hardware files from here, you can also find it from download page of
中文 / 牛人整理的CB2的资料
April 19, 2014, 12:13:26 am

Other / Re: Allwinner A31 + SATA?
March 22, 2014, 11:40:37 am
As i know, A31 has no sata circuit in the chip.
中文 / Re: Cubie在优酷
October 23, 2013, 08:42:24 pm
Accessories / Re: cubie to ardunio shield adaptor
August 25, 2013, 05:03:53 pm
 :) Very good, i like your board!!
hi, do you have make a production for this base board?
Sorry, i can't see very distinctly which component was broken from your photo. is that the white component below?

It is a magnetic beads which is used to connect USB shield to GND and prevent EMI from the USB wire.
The component designator is FB1 in the schematics.

you can just remove this broken component and replace it with short circuit. (a 0 ohm resister of 0805 package, a pieces of wire and a  dot of solders all will be OK) 
in the worst case, i suppose you don't have a soldering iron, cubieboard will work fine without any treatment if it is real that only this one component was broken.

these connectors was bought in ShenZhen China,where are you in?