Author Topic: Accidently connected Cubietruck to 12V supply  (Read 1595 times)

Offline Thetechguy

  • Newbie
  • *
  • Posts: 1
  • Karma: +0/-0
    • View Profile
Accidently connected Cubietruck to 12V supply
« on: June 06, 2017, 09:14:40 am »
I accidently connected cubietruck to 12V supply. The image of the board is attached. And the part that blew up is marked.. Please give the part number so that i can replace it... And please tell whether i should check for damage in other places..
« Last Edit: June 06, 2017, 09:17:33 am by Thetechguy »

Offline Don Pedro

  • Newbie
  • *
  • Posts: 11
  • Karma: +0/-0
    • View Profile
Re: Accidently connected Cubietruck to 12V supply
« Reply #1 on: January 13, 2018, 06:54:15 pm »
From my board I could see this is a capacitor, but as all is SMD it is extremely difficult to recognise any value. I also do think you'll probably have fried the whole board, the capacitor is mainly for stripping of some ripple from the voltage supply and it should run without it when e. g. connected to a battery. So you'll very likely be out of luck. Put the board in the bin and get a new one.