Author Topic: Red Led only power on , nothings happens  (Read 1884 times)

Offline wdsupport

  • Newbie
  • *
  • Posts: 1
  • Karma: +0/-0
    • View Profile
Red Led only power on , nothings happens
« on: May 19, 2016, 03:50:35 am »
My first cubieboardplus , when power on , only the red led turns on, other led to not start.

Offline BaronW

  • Newbie
  • *
  • Posts: 10
  • Karma: +0/-0
    • View Profile
Re: Red Led only power on , nothings happens
« Reply #1 on: May 23, 2016, 01:50:37 pm »
It sounds like your board is dead. If you can't see any video after a few seconds of booting, then you've got a serious problem. Possibly a ROM corruption issue. Try re-flashing the ROM. If that doesn't work, return the board.

Offline specialist383

  • Newbie
  • *
  • Posts: 3
  • Karma: +0/-0
    • View Profile
Re: Red Led only power on , nothings happens
« Reply #2 on: May 26, 2016, 05:04:04 pm »
When I started my CubiePlus board for the first time, I used the CB+ linaro image, transferred with the Win32Imager under Windows to the uSD card of 8 GB. I used the hdmi image and later the hdmi connector. That worked with some delay from the start.
It is a strange Linux installation with a ~old kernel, but all 8 cores are active and it was even possible, to use the CB+ desktop via X11 SSH remotely from the laptop.
Just power LED and nothing could also be a problem with the boot sw. The blinking color LEDs work only after successful start of the sw under program control.