Author Topic: JTAG on cubieboard 4 v1.2  (Read 3492 times)

Offline karpulevich

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
    • View Profile
JTAG on cubieboard 4 v1.2
« on: November 03, 2015, 07:41:25 am »
Hello. I tried to connect to JTAG pins on cubie.
I use USBBlaster + openocd.

I have warning DO is stack at 0 from comand "openocd detect"
I'm sure that I connect cables according to pinouts.

What can I do else?

Offline rgmhtt

  • Global Moderator
  • Full Member
  • *****
  • Posts: 202
  • Karma: +4/-1
    • View Profile
Re: JTAG on cubieboard 4 v1.2
« Reply #1 on: January 25, 2016, 09:50:50 am »
I only have the Cubie2 and Cubietruck, but there should be a TX, RX, & GRD.  Get a USB/TTL adapter, cross the RX & TX, connect GRD and run your favorite serial program, I use 'screen /dev/ttyUSB0 115200', others prefer minicom.  Note serial is 8-N-1 @ 115200 bps.


Offline DineshSudham

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
    • View Profile
Re: JTAG on cubieboard 4 v1.2
« Reply #2 on: May 20, 2017, 04:37:20 am »
Hi,

I am also trying on JTAG ON cubieboard 4 V1.2, I dont have any luck on this,

I took jtag pins out from J20,connected to jtag, not able to see output,

Can you help me on this,if you got luck

Regards,
Dinesh.S.