Author Topic: Quanta touchscreen (ID0408:3008) with Cubian  (Read 2270 times)

Offline jari

  • Newbie
  • *
  • Posts: 5
  • Karma: +0/-0
    • View Profile
Quanta touchscreen (ID0408:3008) with Cubian
« on: December 09, 2014, 07:36:40 am »
I have Viewsonic TD2420 touchscreen monitor with Quanta touchscreen (0408:3008) and A10 with
Linux Cubian 3.4.67+.
I can't get touchscreen work.
If I type 'dmesg | grep usb' I'll get:
...
usb 4-1: new full-speed USB device number 2 using sw-ohci
usbcore: registered new interface driver ushc
...
isn't this ushc a usb host controller? I guess touchscreen should be registered as usbhid?

When I connect touchscreen, its creates /sys/bus/usb/drivers/usbhid/4-1:1.0 folder. In bInterfaceProtocol is 00. It should be 02 for a mouse, right?
In '/proc/bus/input/devices' there are no entries for 4-1:1.0.


What to check next?
lsusb command does not exists; do I have to install usbutils to get touchscreen work?
« Last Edit: December 09, 2014, 09:44:52 am by jari »

Offline jari

  • Newbie
  • *
  • Posts: 5
  • Karma: +0/-0
    • View Profile
Re: Quanta touchscreen (ID0408:3008) with Cubian
« Reply #1 on: February 06, 2015, 02:48:48 am »
Nobody knows anything about this?????

Offline mborras

  • Newbie
  • *
  • Posts: 13
  • Karma: +0/-0
    • View Profile
Re: Quanta touchscreen (ID0408:3008) with Cubian
« Reply #2 on: May 28, 2015, 05:21:40 am »
Did you have any progress? I have same problem with a 3M touchsreen.