Author Topic: Cubieboard case - review  (Read 3129 times)

Offline castalla

  • Developer
  • Full Member
  • ***
  • Posts: 106
  • Karma: +3/-0
    • View Profile
Cubieboard case - review
« on: April 30, 2013, 08:33:03 am »
I just received the 'official' case today. 

It's very well made.  The board is a very tight fit - be careful how you push the board into the casing!

The OTG power plug enclosure is too small for many plugs to fit if they have a molded case - I was fortunately able to strip back the cable's plastic molding enough using a very sharp modelling knife.

There are no plastic or rubber pads provided to stop the box sliding on slippy surfaces.

Score: 7/10